Table of Contents
Advertisement
Figure 3-8: LED Light and SMV Harness Wire Designations (After August, 2013)
LED Light and SMV Bracket
Installation (After August, 2013)
NOTE
For placement of light brackets, see Figure 2-5.
1. Attach left and right light brackets with reflectors to
center frame using u-bolts and hex lock nuts
Figure
3-7) The yellow reflectors will face forward on
the machine. Note that the ag amber single LED
lamps are already assembled in the brackets.
2. Attach left tail light mount to frame assembly using
u-bolt and 5/8-11 flange head serrated nuts.
3. Attach ag flasher control module to the right tail light
mount using 1/4-20 x 1-1/2 hex head cap screws and
hex lock nuts. Attach right tail light assembly to frame
assembly using u-bolt and 5/8-11 flange head
serrated nuts. Be sure that the control module is set
so that the 6 pin connector faces the right side of the
machine.
4. Attach the ag red single LED lamps to tail light
mounts and reflector assemblies using 1/4-20 x 1-1/2
hex head cap screws and hex lock nuts.
IMPORTANT
Make sure lights are positioned for maximum
visibility from the rear.
5. Install the rear warning light harness to the frame.
Connect 2 pin and 3 pin ends to each of the warning
lights. Connect 6 pin to the ag flasher control module.
See Figures 3-8
for LED harness wire
designations.
6. Attach front warning harness to frame. Connect 4 pin
end to the ag flasher control module.
7. Insure that the harnesses are clear of any moving
parts and secure the harnesses with tie wraps
provided.
8. Install the stor-away holder to hose holder on hitch
with 1/4-20 x 1 hex head cap screws and hex lock
nuts.
9. Attach SMV emblem and mounting bracket to rear
center frame bar using u-bolt, 1/4-20 x 1 hex head
cap screws, and hex lock nuts. The SMV sign should
be centered on the back bar of the frame.
(See
ASSEMBLY INSTRUCTIONS
3-13
Advertisement
Table of Contents
