Landoll 9650 FC Operator's Manual page 102

ASSEMBLY INSTRUCTIONS
Leveling Linkage Assembly
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.

Do not attempt to lift heavy parts (such as the
frame, rock shaft, and pull hitch) manually. Use a
hoist or a fork lift to move these parts into
position.
3-6
WARNING
NOTE
If installing optional rear tow hitch, see
(Option)" on page 3-32. Install rear tow hitch before
connecting leveler tube.
1. Slide leveler tube under the wing stabilizer.
2. Attach rear of leveler tube to the center lift using hitch
pin, 1-1/2 flange bearings, 1/2 x 2-1/4 grooved alloy
pin, and 1-8 hex lock nut
3. Attach leveler tower to the rear of hitch using 1-1/4-7
x 9-1/2 hex head cap screw, 1-1/4-7 split lock washer,
and hex nut.
4. Attach the top of the leveler tower to the leveler tube
with hitch pin, 1-1/2 flange bearings, 1/2 x 2-1/4
grooved alloy pin, and 1-8 hex lock nut.
5. Assemble radius rod assembly to top front hole in the
leveler tower using 1-1/4-7 x 8 special hex head cap
screw, flat washers, split lock washer, and hex nut.
6. Attach front of radius rod assembly to hitch using
1-1/4-7 x 8 special hex head cap screw, flat washer,
split lock washer, and hex nut.
"Rear Tow Hitch
See Figure 3-3.
F-605-0221