Vaxcel T0435 Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
T0435
W
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d'alimentation principale au panneau
central de disjoncteurs avant d'installer le luminaire.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Important to Know
1. Read all instructions carefully before installation and
operation.
2. If you are not familiar with state and local electrical codes
it is recommended that you consult with a qualified
electrician.
3. Before installation, shut off power at the main fuse or
circuit breaker box. Be aware that simply turning off the
wall switch is not sufficient to prevent an electrical shock.
4. This fixture requires a 120V AC, 60 Hz power source.
5. Do not attempt to take the lantern apart; there are no
serviceable parts inside.
6. To avoid sensor damage by lightning or electrical surge,
make sure the ground wire is securely connected.
7. For general safety and to avoid any possible damage to
the sensor, be sure the power is switched "off" before
replacing the bulb.
8. Compatible with most LED dimmable bulbs.
Maximum Wattage: 60W Bulb
Work Temperature: - 22°F~104°F
House Ground Wire
Wire Connector (C)
Cross Bar Unit (A)
Headless Screw
Green Ground Screw
Mounting Screw (B)
Fixture Ground Wire
INSTRUCTIONS
Outlet Box
Fixture Wire
Features
1. Energy saving fixture.
2. Use dim-to-full brightness where dim-illumination
is preferred, such as your front entrance. Use
,
off-to-full brightness where off/on illumination is
preferred, such as your backyard.
3. When in manual override mode, use wall switch
to keep the light ON till dawn.
Hardware Package (included)：
Cross Bar Unit (A)
Wire Connector (C)
Backplate
Page 1 / 5
Mounting Screw (B)
Bolt Nut (D) Rubber Pad (E)
Rubber Pad (E)
Bolt Nut (D)
Socket
Max.60W Type A Bulb
(not included)
220720