Vaxcel T0476 Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
T0476
WARNING:
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Wire Connector (B)
Fitter Screw (A)
Installation Steps
Turn off the power at fuse or circuit box
1. Unscrew the loop to remove the rubber pad and cover.
2. Unscrew the hex nut and washer from the threaded
pipe to remove the upper cover.
3. Gently place four glass panels into the metal frame,
then press the clips to secure the glass panels. (Fig.1)
Note: The patterned side of faces glass out.
Glass Panel
Clip
Metal
Frame
4. Install a bulb (not included). See relamping label
at socket area or packaging for maximum allowed wattage.
5. Attach the upper cover, washer, hex nut, cover, rubber pad
and loop to the threaded pipe.
6. Pull out the wires and grounding wire from the post.
Make wire connections using the wire connectors (B):
---The black wire from the fixture to the black wire
from the post.
---The white wire from the fixture to the white wire
from the post.
---The grounding wire from the fixture to the grounding
wire from the post.
Carefully put the wires back into the post.
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Fig.1
Hex Nut
Threaded Pipe
Iron Plate
Photocell
Loop
Rubber Pad
Cover
Washer
Upper Cover
Glass Panel
Bulb Type A Max.60W
(not included)
Metal Frame
Fitter
Fitter Screw (A)
Fixture Wire
Wire Connector (B)
Grounding Wire
Post
181220