Change To Mode1 - FUTABA T6L Sport Instruction Manual

The following sequence illustrates how to
change the T6L from 'Mode 2' into 'Mode 1'.
The ratchet mechanism must be changed to
the other side. This can be difficult to perform
so if in doubt please contact your local Futaba
Service center.
1
Open the battery cover on the back of the
transmitter and remove the transmitter battery.
2
Remove the four transmitter rear case
screws and remove the rear case.
Swing arm
Spring
4
Remove the ratchet plate /swing
arm/spring on the gimbal section.
CHANGE TO MODE 1
RUD
AIL
Ratchet plate
AIL
RUD
ELE THR THR
MODE 1
MODE 2
RUD
AIL
ELE THR THR
MODE 3 MODE 4
3
5
Change the ratchet plate /swing arm/
spring on the gimbal section.
6
Install the rear case.
AIL
ELE
RUD
ELE
.
This part is cut
23