Table of Contents
Advertisement
5.4
Fire Detectors series ES Detect
The ES Detect automatic detector is an intelligent non-addressable detector specifically designed for operation
on conventional detector zones e.g., the ES line fire alarm control panel and esserbus
sets new standards in conventional technology through high quality sensors with advanced detection
technology. These include not only the intelligent algorithms for fire detection but also the wide range of different
types of detectors, including multisensor detectors OT
ES Detect also helps to save costs, because with the implemented drift compensation, ES Detect can be
operated a full eight years, instead of five years for ordinary detectors, according to DIN 14675.
Numerous accessories are available from the compatible program of the IQ8Quad detector series.
The convenient maintenance with the programming software tools 8000 (in preparation) completes the full
spectrum of ES Detect, from which the operating data of the detector (for example, the measured values,
contamination, alarm counters, operating hours counter ...) can be read and stored. The detectors remain where
they were installed, because the complete detector group can be connected to a PC and serviced via the field
bus and control panel interface Plus (Part No. 789862.10).
Fig. 5: Fire Detectors series ES Detect
Features
Optimally matched to the ES Line system.
•
Optical differentiation with the ES Detect logo.
•
With multisensor detectors for the detection of all fires, even under the most difficult operating conditions
•
Up to 30 detectors per detection zone.
•
•
Uniform response sensitivity of the detector for all different types of fire for the multisensory detectors
•
Large distance between signal and interference magnitudes due to special sensor and electronics design
for suppressing IQ8Quad with integrated alarm device electromagnetic influences
•
Automatic adaptation to varying environmental influences
•
Electronic compensation of long-term influences of contamination or aging
High reliability against false alarms by temporal evaluation of different sensor criteria
•
Exclusion of signal forms not typical of fires through special filter algorithms
•
Automatic self-monitoring of the detector electronics
•
Automatic self-monitoring of sensors for function and condition
•
Maintenance
Designation of the heat detector by a black ring on the light pipe
•
Hours of operation, alarm and fault counter in each detector
•
Collection of the operating data from all detectors in a zone using a standard service PC and via the fieldbus
•
and control panel interface Plus
Detector LED for alarm display and as an identification disp
•
tools 8000)
•
The service functions of the ES Detect series fire detectors are supported by the service and programming
software tools 8000 V1.24 and later. The detector zones of the FACP with the red end-of-line element EOL-I
(Part No. 808626) must be terminated.
Wide range of accessories
•
Standard socket and relay base
•
Socket adapter for ceiling installation
•
Dust caps optional for fire detectors and detector base
•
Kit for suspended mounting.
TI 798960.GB0 / 04.20
Periphery components for ESSER FACP
blue
and O²T.
in the service (for maintenance with
lay
®
transponder. ES Detect
21
Advertisement
Table of Contents
