How To Manually Raise An Alarm Of Fire - Honeywell GENT Vigilon Plus Series Operating Instructions Manual

How to manually raise an alarm of FIRE

If you see a fire in the protected premises and want to raise a fire
alarm to warn occupants in the building, you can do this manually by:
Going to the nearest manual call point that is located away from
†
the fire hazard.
Press hard with a thumb onto the centre of the glass until it breaks.
†
Manual Call point
The 'Zone indicators' are not applicable
at a Vigilon Plus Network Node
1
Zones
Fault
1stFIRE:MCP:Zone 1
Power Fault
First Fire occurred at:
System Fault
Time: 15:43.10
Delay
Test
Disablement
www.acornfiresecurity.com
Panel
buzzer
15:45
Wed 16 March 2016
Previous Next
If configured this light indicates there is an active Fire routing
output to Alarm Receiving Centre to initiate Fire fighting action.
www.acornfiresecurity.com
With the panel door open:
†
To cancel
buzzer
To silence
alarms
To reset
system
On Flashing
Fire
Verify
Sounder
Fire Active
Routing
O/P
Fault/Dis
Power
Record
the event
Vigilon Plus fire alarm system
You can stop the panel buzzer from
sounding.
CANCEL
BUZZER
Press:
Display reads: 'Buzzer cancelled'
When the emergency is over the
alarm sounders can be silenced.
SILENCE
ALARMS
Press:
Display reads: 'Alarms silenced'
To return the system to normal
condition clear any residual smoke
or heat from sensors and reset
element or replace the glass in any
manual call point where the glass
was broken.
Ensure the fire system is checked
by your servicing organisation if
there has been fire damage in the
protected area.
RESET
Press:
Display reads 'System being Reset -
please wait....'
Make an entry in the log book of the
event for future reference.
13