TOHATSU MFS 3.5C Owner's Manual page 64

64
EMISSION CONTROL SYSTEM INFORMATION
ENOM01005-0
Problems that can affect emission
If you notice any of the following symp-
t o m s, h a v e y o ur o u t b o a r d m o t or
inspected and repaired by an authorized
Tohatsu service dealer before further
use.
Hard starting or stalling immediately
after starting
Rough idling
Misfiring/backfiring under load
Afterburning (backfiring)
Black exhaust smoke or increased fuel
consumption
ENOM01006-0
Replacement Parts
The emission control system in your
Tohatsu out board motor has be en
designed, built, and certified to conform
with the EPA and California emission reg-
ulations. Whenever requesting mainte-
nance, use of Tohatsu Genuine parts is
highly recommended. Tohatsu Genuine
parts constitute replacement parts man-
ufactured to the same high standards as
the original parts, thus guaranteeing
uninterrupted high performance of your
outboard motor. The use of replacement
parts other than Tohatsu Genuine parts
could jeopardize the effectiveness of the
emission control system.
Tohatsu, as a manufacturer of aftermar-
ket parts, assumes the responsibility that
replacement parts will not adversely
affect emission performance. The manu-
14
facturer or rebuilder of the replacements
parts must certify that use of the parts
will not result in a failure of the engine to
comply with these regulations.
ENOM00033-0
2.
Low permeation fuel hose
requirement
EQUIPPED FOR UNITED STATES AND
CANADA MODEL
Required for outboards manufactured
for sale, sold, or offered for sale in the
United States.
TOHATSU engine has used fuel hoses
for The Environmental Protection
Agency (EPA) requires from January 1,
2011.