TOHATSU MFS 3.5C Owner's Manual page 49

ENOM00098-B
Gear oil replacement
ENOW00094-0
WARNING
Be sure that outboard motor is secured to
transom or service stand, or accidental
drop or fall of outboard motor could lead
to severe personal injury.
Be sure to lock outboard motor if it is
tilted up, or accidental fall of outboard
motor could lead to severe personal
injury.
Do not go under outboard motor tilted up
and locked, or accidental fall of outboard
motor could lead to severe personal
injury.
1. Tilt down the outboard motor.
2. Remove the oil plugs (lower and
upper), and completely drain the gear
oil into a pan.
3. Insert the oil tube nozzle into the
lower oil plug hole, and fill with gear
oil by squeezing the oil tube until oil
flows out of the upper plug hole and
bubbles is disappeared to remove the
air.
ENON00033-0
Note
Use genuine gear oil or the recommended
one (API GL-5: SAE #80 to #90).
Required volume: approx. 180 mL (6.1
fl.Oz).
4. Install the upper oil plug, and then
remove oil tube nozzle and install the
lower oil plug.
Oil plug specified tightening torque
4Nm (3 ft
ENOW00095-0
Do not reuse oil plug gasket. Always use new
gasket and tighten oil plug properly to pre-
vent entry of water into lower unit.
ENOF01617-0
INSPECTION AND MAINTENANCE
lb, 0.4 kgf m)
- -
CAUTION
49
ENOF01618-0
10