Table of Contents
Advertisement
The following scenarios affect the sensor state:
•
If a gun or taser is removed from the holster within the timer duration, the timer stops
and switches the sensor to disabled state. A tone sounds and the radio displays Sensor
Disable.
NOTE: The radio enables the sensor only when all the guns or tasers are placed into
the holster. A tone sounds and the radio displays Sensor On temporarily.
•
If the timer expires without an event, a tone sounds, the radio switches the sensor to enabled
state, and clears the sensor status from the display.
•
If the preprogrammed Sensor button is long-pressed, the OTA sensor notification is enabled.
7.19.2.4.2
Disabling the Sensor Permanently
Procedure:
1 Long-press the preprogrammed Sensor button to permanently disable the sensors.
A tone sounds and the radio displays Sensor Off. While in this state, no events is reported
over-the-air (OTA), regardless of how many times the gun is drawn, re-inserted or weapon is
fired.
The radio generates a bad key tone if the sensor is not allowed to be disabled or there is
no sensor connected to the radio when the preprogrammed button or menu select button is
pressed.
2 Long-press the preprogrammed Sensor button again to enable the OTA Sensor notification.
A tone sounds, and the radio displays SNSR OFF.
7.20
ASTRO 25 (P25) Programming Over Project 25 (POP25)
Also called Over-the-Air Programming, this feature allows configuration data and firmware to be
upgraded to your radio over-the-air. Full use of the radio is retained during the data transfer without
interrupting communication.
If the upgrade happens on the ASTRO 25 and ASTRO Conventional systems, the upgrade pauses to
give priorities to voice call, and continues after the voice call ended. If the upgrade happens on a Wi-Fi
network, the upgrade process runs concurrently with voice calls.
Once a configuration upgrade is downloaded to your radio, you can install new changes immediately,
or delay changes to be installed on the radio when it is being powered up.
Your radio can also be configured to allow you to accept or reject an upgrade.
NOTE: The Remote Speaker Microphone (RSM) firmware updates are carried out by the radio.
Your radio will not show any notification as the updates are happening in the background.
MN002667A01-AV
Chapter 7 : Advanced Features
69
Advertisement
Table of Contents
