Table of Contents
Advertisement
MN002667A01-AV
Chapter 7 : Advanced Features
The radio exits Emergency Alarm and enters the Emergency Call state when one of the
following scenarios occur:
•
You receive the dispatcher acknowledgment. The display shows ACK RCVD.
•
You receive no acknowledgment. The display shows NO ACK.
•
You press the PTT button while in the Emergency Alarm mode.
If unsuccessful, you hear the radio sounds a short low-pitched tone to indicate the selected
channel does not support emergency and rejects to launch emergency mode.
2 Hold the radio vertically 1 to 2 inches (2.5 to 5.0 cm) from your mouth.
3 Press and hold the PTT button. Speak clearly into the microphone.
4 Release the PTT button to end the transmission and wait for a response from the dispatcher.
5 To exit Emergency Call, press and hold the preprogrammed Emergency button for about a
second.
Turning off the radio also cancels the emergency state.
7.9.10
Sending An Emergency Alarm and Call with Hot Mic
This feature allows you to send an Emergency Alarm and Call with hot mic to a group of radios.
When and where to use: Your radio must be programmed for this type of operation.
When indirect PTT such as Hot Mic is activated, the audio transmission can be configured in CPS
to route the audio to the radio internal microphone, wired RSM microphone, or Bluetooth wireless
microphone.
Follow the procedure to send Emergency Alarms and Call with hot mic on your radio.
Procedure:
1 Press the preprogrammed Emergency button.
If successful, the display shows EMERGNCY on the current zone and channel. A tone sounds and
the LED blinks red momentarily.
The radio exits Emergency Alarm and enters the Emergency Call state when one of the
following scenarios occur:
•
You receive the dispatcher acknowledgment. The display shows ACK RCVD.
•
You receive no acknowledgment. The display shows NO ACK.
If unsuccessful, a tone sounds to indicate that the selected channel does not support emergency
and rejects to launch emergency mode.
2 The microphone remains active for the hot mic time specified in your radio's codeplug
programming.
3 To exit Emergency Call, press and hold the preprogrammed Emergency button.
Turning off the radio also cancels the emergency state.
52
Advertisement
Table of Contents
