Table of Contents
Advertisement
Code
P1329 Knock Sensor Loose Detection
P1617 Starter Relay Circuit Short to Ground
P1636 Crank Angle Sensor Circuit
P1639 Exhaust Valve Position Sensor Circuit
Low
P1640 Exhaust Valve Position Sensor Circuit
High
P1645 Exhaust Valve System Malfunction
P1646 Exhaust Valve Actuator
Self-Cleaning Open Error
P1647 Exhaust Valve Actuator Short Error
P1755 Engine RPM Sensor Circuit
Malfunction
P2228 Barometric Pressure Sensor (A)
Circuit Low
P2229 Barometric Pressure Sensor (A)
Circuit High
P3001 Control Module Improper Shutdown
U0132 Lost Communication with Suspension
Control Module
U0155 LCD Gauge Communication Lost
U1000 Vehicle not registered or invalid PIN
entered
U1001 Vehicle not registered and vehicle
limits enabled
U1212 Lost Communication with Left
Handlebar Control
Handlebar Tilt
1. Remove the handlebar cover (if
equipped); then loosen the eight cap
screws securing the handlebar caps to
the riser and the riser to the steering
post.
2. Adjust the handlebar to operator's
desired position, tighten the cap
screws evenly to 2.7 kg-m (20 ft-lb),
and check steering for maximum
right/left turning capabilities.
Trouble
ONS-069
NOTE: Do not rotate the handlebar
to a position that allows air to enter
the brake system.
! WARNING
Tighten cap screws according to
specifications to prevent unexpected
"movement" of the handlebar during
operation over rough terrain. DO NOT
position the handlebar so steering
(maximum right/left turning capabili-
ties) or throttle and brake controls
are affected.
Exhaust System
The exhaust system is designed to reduce
noise and to improve the total perfor-
mance of the engine. If any exhaust sys-
tem component is removed from the
engine and the engine is run, severe
engine damage will result.
Air-Intake Silencer
Used in conjunction with the fuel intake
system is a specially designed air-intake
silencer. The purpose of the silencer is to
quiet the intake of fresh air. Since the fuel
intake system is calibrated with the air-
intake silencer in place, the engine must
never be run with the silencer removed.
Performance will not be improved if the
air-intake silencer is removed. In con-
trast, severe engine damage will occur.
Cooling System
These snowmobiles are equipped with a
closed liquid cooling system for engine
cooling. The cooling system should be
inspected daily for leakage and damage.
Also, the coolant level should be checked
daily. If leakage or damage is detected,
take the snowmobile to an authorized
Yamaha Snowmobile dealer for service.
If not under warranty, this service is at
the discretion and expense of the snow-
mobile owner.
When filling the cooling system, use an
ethylene glycol-based coolant/water mix-
ture which will satisfy the coldest antici-
pated weather conditions of your area in
accordance with the coolant manufac-
turer's recommendations.
9
Advertisement
Table of Contents
