Table of Contents
Advertisement
2. If the deflection (distance between
the bottom of the wear strip and the
inside surface of the track clip)
exceeds specifications, tighten the
adjusting bolt(s) to take up excessive
slack in the track.
3. If the distance between the bottom of
the wear strip and the inside surface
of the track clip is less than specified,
loosen the adjusting bolts to increase
the slack in the track.
CAUTION
Always maintain track tension within
recommended specification.
4. After
proper
obtained, tighten the idler wheel axle
cap screws to 4.7 kg-m (34 ft-lb);
then tighten the adjusting bolt
securely against the rail.
! WARNING
Always make sure the adjusting bolt
is snug against the rail and the idler
wheel cap screws are tightened to
specifications. Failure to do so could
cause the track to become extremely
loose and, under some operating
conditions, allow the idler wheels to
climb over the track lugs forcing the
track against the tunnel causing the
track to "lock." If a track "locks"
during operation, severe personal
injury could result.
SXVenom/Transporter/
Transporter Lite
NOTE: To ensure proper track ten-
sion adjustment, perform all adjust-
ments
on
both
snowmobile.
1. Loosen the idler wheel axle cap
screws.
track
tension
sides
of
the
is
2. If the deflection (distance between
the bottom of the wear strip and the
inside surface of the track clip)
exceeds specifications, tighten the
adjusting bolt(s) to take up excessive
slack in the track.
3. If the distance between the bottom of
the wear strip and the inside surface
of the track clip is less than specified,
loosen the adjusting bolts to increase
the slack in the track.
CAUTION
Always maintain track tension within
recommended specification.
4. Check track alignment.
5. After
proper
obtained, tighten the idler wheel axle
cap screws to 4.7 kg-m (34 ft-lb);
then tighten the adjusting bolts
securely against the axle.
0755-111
0755-110
track
tension
39
is
Advertisement
Table of Contents
