Yamaha SXV4NP Operator's Manual page 8

E. Coolant Temperature/
Battery Voltage/Intake Air
Temperature/Exhaust
Temperature Display
This bar display shows coolant tempera-
ture, battery voltage, intake air tempera-
ture, and exhaust temperature. Press the
Lower Left Button to change which
parameter is being displayed. Press and
hold the Lower Left Button to see the
actual values associated with the mode
selected.

NOTE: The right toggle of the
gauge control button is the same as
the lower left button on the gauge.
E. Hand Warmer Display
This bar display shows the handlebar
warmer and thumb warmer settings. The
right toggle of the button will increase
the warmth setting and the left toggle will
decrease the warmth setting.
F. Fuel Level Display
This bar display shows the approximate
amount of gas remaining in the gas tank.
G. RPM/Speed/Clock/
Altimeter
Press the Upper Left Button to cycle the
left screen between RPM and speed.
6

NOTE: The left toggle of the gauge
control button is the same as the
upper left button on the gauge.

NOTE: When RPM is displayed on
the left screen, the right screen will
display speed, clock, or altimeter.
When speed is displayed on the left
screen, the right screen will display
RPM, clock or altimeter.
Press the Upper Right Button to cycle the
right screen between speed, RPM, clock,
and altimeter.
Press and hold the Upper Button on the
speed-side of the gauge to shift between
standard (mph, miles and Fahrenheit) and
ONS-068
metric (km/h, kilometers and Celsius).
Press and hold the Upper Button on the
RPM-side to view maximum RPM. This
value is reset by pressing and releasing
the lower right button while maximum
RPM is displayed.
With the clock mode selected by pressing
the Upper Right Button, press and hold the
Upper Right Button to set the clock. The
option of selecting the 12-hour or 24-hour
clock is available; press either Left Button to
alternate between the two modes. Next,
press the Lower Right Button to set the
clock. Press either Left Button to set the
hours; then press the Lower Right Button to
reach the minutes. Press either Left Button
to set the minutes. When the proper time has
ONS-304
been set, press the Lower Right Button to
return to the main gauge display.
With the altimeter mode selected by
pressing the Upper Right Button, press
and hold the Upper Right Button to set
the current altitude by using either Left
Button. When the proper altitude has
been set, press the Lower Right Button to
return to the main gauge display.
ONS-068