Preparing The Water Hose And The Electrical Connection; Installation In The Cabinet - Bertazzoni REF18FCBIPRV Installation Manual

3. INSTALLATION INSTRUCTIONS
3.3 Preparing the Water Hose and the
Electrical Connection
Inspect all water connections for leaks. Water
leaks can cause significant damage over time.
It is recommended to use a ¼" water line with a
minimum length of 60" (1.5 meters) with a threaded
¼" female connector end. Before finishing the
installation, turn the water on to ensure that water
is flowing and that there are no leaks.
A connector that has a thread with an external
diameter of ¼" must be used to connect the end of
the hose to the product.
Allow for sufficient slack in the water supply line,
providing a minimum of 10" of length from the
base of the unit once it is installed in the niche.
This provides some allowance for connections and
adjustments if needed.
The product must be connected to a 3-prong outlet
on a dedicated 15 amp circuit; local electrical and
building codes should be respected.
You can choose method A or method B below to
prevent the power cord from getting wedged in.
• Method A: Position the water hose and the power
supply connections on the back.
Power cord location
Water line location
24
• Method B: Position the water hose and power
supply connections on the side.
Keep open for water line
Water hose

3.4 Installation in the cabinet

Taking the Refrigerator from the Wooden Pallet
• Remove the brackets
refrigerator to the wooden pallet as shown below.
• Slowly tilt the refrigerator back and remove it
from the pallet, taking care not to damage the
underside of the unit. When transporting the unit,
always carry it from the sides to ensure that the
unit's feet remain on the base of the appliance
dolly.
Keep for power cord
which secure the