Bertazzoni REF18FCBIPRV Installation Manual page 38

3. INSTALLATION INSTRUCTIONS
The fridge door hanger sheet and fridge door
upper mechanism assembly must be on the upper
part of the door.
Attach the door handle to the upper door panel prior
to installing the panel on the fridge. Use handle
hardware that will ensure a secure connection to
the panel and that will lie flush against or, in any
case, not protrude from the back of the overlay
panel. This may require countersinking the handle
hardware into the back of the panel, as shown
below. The door handle mounting screws must not
protrude either.
REF18FCBIPRV / REF18FCBIPLV
REF24FCBIPNV
REF24RCBPNV
REF30RCBPNV
WARNING:
The handle mounting holes will have to be
adjusted based on the handles to be used in
the kitchen design.
WARNING:
The minimum door thickness must be ¾"
(19 mm).
WARNING:
To prevent damage to the finished surface
of the panel, use screws suitable for the
door thickness.
38
ALIGNING THE UPPER PART OF THE CUSTOM
DOOR PANEL WITH BOLTS
• The custom panel for the refrigerator must be
flush with the cabinet doors beside it.
To achieve this, it is necessary to adjust the 3D
direction using two fixing bolts.
First, check the position of the refrigerator door in
relation to the kitchen cabinets.
The distance between the door and the cabinets
beside it should be 3 mm (1/8"), assuming that the
door dimensions are correct.
You can now adjust the door according to this
distance.
Up&Down
Front & back
Left & right
Fixing furniture door
completely