Hydrocarbon (Hc) Warning; For Appliances With A Water Dispenser/Ice Machine - Bertazzoni RFD90S5FPNS-GM User And Maintenance Manual

Table of Contents

Advertisement

IMPORTANT INFORMATION REGARDING SAFETY AND THE ENVIRONMENT
CAUTION
Risk of Fire or Explosion:
This product uses flammable refrigerant.
Do not use mechanical devices to defrost
the refrigerator.
Do not use chemicals for cleaning.
Do not pierce the refrigerant tubing.
If the refrigerant tubing is pierced, it must
be repaired only by licensed service
personnel.
Please consult the maintenance and use
manual before cleaning the product. All
safety instructions must be followed.
Dispose of the product in accordance
with federal or local regulations.

HYDROCARBON (HC) WARNING

Your product's cooling system contains R600a. This gas is
flammable. Therefore, be careful not to damage the cooling
system or the tubing during use or transportation. If
damaged, keep the appliance away from potential sources
of ignition, which could cause it to catch fire, and ventilate
the room where the appliance is placed.
NOTE
If the appliance is damaged or if you see a
gas leak, please keep away from the gas. It
may cause ice burn if it comes into contact
with the skin.
NOTE
The type of gas used in the product is listed
on the rating label, which is located on the
left interior wall of the refrigerator.
WARNING
Never attempt to burn the product as a means
of disposal.
FOR APPLIANCES WITH A WATER
DISPENSER/ICE MACHINE
The operating pressure for the cold water inlet is 1.7-5.5
bar (25-80 psi). If the water pressure exceeds 5.5 bar
(80 psi), install a pressure limiting valve to your mains
system.
If the water mains pressure is lower than 1.7 bar (25
psi), you can use an auxiliary pump to compensate for
the low pressure.
If you do not know how to check the water pressure,
please consult a professional plumber.
If there is a risk of water jet impact during your
installation, make sure to use water jet impact protection
equipment during installation.
Please consult a professional plumber if you are not
sure if your installation involves a water jet impact risk.
Do not install anything on or over the hot water inlet.
Take the necessary measures to prevent any risk of the
hoses freezing.
The operating water temperature range is between a
minimum of 1℃ (34℉) and a maximum of 38℃ (100℉).
WARNING
Never connect the product to a cold-water
mains system with a pressure higher than 5.5
bar (80 psi).
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rfd90s5fpns

Table of Contents