Installation; Connecting To The Water System - Bertazzoni REF 5BB TT Series User Manual

2. INSTALLATION

2.1 Installation
Make sure that the installation is performed
correctly, in accordance with all of the instructions
in the specific installation manual provided with the
appliance.
Warning
Always connect the water before
connecting the power.
The appliance must be connected to ground in
compliance with electrical system safety standards.
> Position the appliance with the aid of a second
person.
> Never use the open door to lever the appliance
into place when fitting.
> Avoid exerting too much pressure on the door
when open.
> The appliance must not be installed near heat
sources. If this is not possible, suitable insulation
must be used.
>The appliance must not be exposed to direct
sunlight.
> Do not use the appliance outdoors.
> Installation and servicing should be carried out
by qualified personnel in accordance with current
standards.
> Ensure that an authorised technician performs
the electrical connection.
> If the power supply cable is damaged, ensure
against hazards by contacting technical support
immediately and they will replace it, so as to
prevent any risk.
> Always put on the necessary/required Personal
Protective Equipment (PPE) before performing any
work on the appliance (installation, maintenance,
positioning or movement).
> Before performing any operation involving the
appliance, switch off the power supply.
> This appliance can be used up to a maximum
altitude of 4,000 metres above sea level.
>If installed near another refrigerator or freezer,
keep it at a minimum distance of 2 cm.
>Do not try to repair the appliance yourself or
without the assistance of a qualified technician.
>Do not install/use the appliance outdoors.
>CAUTION: Make sure that the power supply
cable does not become caught or damaged when
positioning the appliance.
>To ensure the appliance is stable, install and
secure it correctly as described in the instructions
provided in this manual.
48

2.2 Connecting to the water system

Models equipped with an Ice Maker require a
connection to the domestic water supply system.
This can be established solely by using the provided
¼" water line.
The system pressure must be between 0.05 MPa
and 0.5 MPa (between 0.5 bar and 5 bar).
Any pressure outside of this range may cause the
water system to malfunction or leak. This appliance
should be supplied only with potable water.
Warning
This appliance should be supplied only
with potable water.
Warning
Make sure that installation is performed
correctly and in accordance with all of the
instructions in the specific installation
manual provided with the appliance.
Warning
Do not attempt to use a locally-sourced
threaded garden hose adapter or braided
supply line. It will strip the threads on the
appliance's water connection solenoid.