Table of Contents
Advertisement
3.5.3.4 Update Sensor Firmware
In order to update sensor firmware:
1.
Click Select File
NOTE: Please contact Smart Sensor for Mechanical
Products technical support by phone at +1 864-284-
5700 ext. 6 or by email at us-mptsensortechsupport@
abb.com to obtain the sensor firmware file.
Figure 26 - Select File
2.
Locate the sensor firmware file (on your PC) and click
Open
Figure 27 - Select Sensor Firmware
Click Install
3.
Figure 28 - Install Sensor Firmware
4.
Wait for the new firmware installation to complete.
Figure 29 - Install Sensor Firmware
3.6 Replacing a Sensor
In case of a faulty sensor or a depleted sensor battery, replace
the old sensor with a new sensor using the steps below:
1
Delete the defective sensor from the monitoring list
inside the OPC-UA and EtherNet/IP pages.
Figure 30 - Delete Sensor
7
DODGE® On-Premise Gateway User Guide
Advertisement
Table of Contents
