Figure 4 - EtherNet/IP Page
3.1 Adding Sensors to Monitoring List
From the OPC-UA page (or EtherNet/IP page):
Click Scan
1.
2.
Click Add on the chosen sensor.
Figure 5 - Add Sensor to OPC-UA
NOTE: To add a sensor on the EtherNet/IP page, input the IP
address to the PLC controller.
Figure 6 - Add Sensor to EtherNet/IP
After adding the sensors, the gateway will start to synchronize
the sensors' clocks. Wait for the synchronization process to
complete on all sensors and press OK
Figure 7 - Sensor Synchronization
3.2 Deleting Sensors from Monitoring List
To delete sensors from the monitoring list:
1.
Select Sensors in the monitoring list.
Click Delete
2.
Figure 8 - Delete Sensors
3.
Click Yes
Figure 9 - Delete Sensors Confirmation
3
DODGE® On-Premise Gateway User Guide