Table of Contents
Advertisement
5
Save the project. Upload tags when prompted.
Figure 48 - Upload Tags Prompt
6.
Navigate to monitor tags
Figure 49 - Monitor Tags
5.3 CIP Server Operation
5.3.1 Viewing Sensor Details
Ensure CIP operation is selected. Refer to section 51
Changing EtherNet/IP Operation
To view selected sensor details:
Click Details for selected sensor.
1.
Figure 50 - Viewing Sensor Details
The Measurement tab contains information specific to the
sensor such as the MAC address, the serial number, the list
of Input Array and the sensor parameters data from the last
measurement performed.
Figure 51 - Measurement Tab
See table below with Input Array and their types.
Parameter
Serial Number
Acceleration RMS
Velocity RMS
Surface Temperature
Timestamp
Units
NOTE: Number inside brackets represents an index number in
Input Array in CIP Server.
5.3.2 Configuring CIP Server inside Studio 5000
1.
Launch Studio 5000 and create new project
Figure 52 - Create New Project
2.
Click on Logix tab
Select a PLC type and type a name for the project in
3.
the Name field.
Click Next
4.
Figure 53 - Select PLC Type & Name New Project
5.
Click Finish New instance of Logix designer will be
opened.
11
DODGE® On-Premise Gateway User Guide
Input Array
Type
I.Data[0]
DINT
I.Data[1]
DINT
I.Data[2]
DINT
I.Data[3]
DINT
I.Data[4]
DINT
I.Data[5]
DINT
Advertisement
Table of Contents
