Viewing Sensor Details; Measurement Tab - ABB Cassia DODGE User Manual

3. Click Restore
Figure 16 - Restore Configuration Confirmation

3.5 Viewing Sensor Details

Once all sensors have been added, the sensor data can be
viewed from within the OPC-UA or EtherNet/IP page:
• Click Details for the desired sensor.
Figure 17 - Sensor Details Selection
The sensor details screen from the OPC-UA page contains 2
tabs, while the EtherNet/IP page contains 3 tabs.

3.5.1 Measurement Tab

The Measurement tab inside the OPC-UA page contains
information specific to the sensor such as the MAC address,
the serial number, and the sensor parameters data from the last
measurement performed.
Figure 18 - Measurement Tab
The Measurement tab inside the EtherNet/IP page contains
the same information as the OPC-UA page, in addition to a
column based on the selected EtherNet/IP operation.
For selected CIP Server operation, there is an Input Array
parameter.
Figure 19 - Input Array Parameter
For selected EtherNet/IP tag writer operation, there is a PLC
Tag parameter.
Figure 20 - PLC Tag Parameter
For more information about how to change EtherNet/IP
operation, please refer to section 51.
NOTE: To learn more about what each sensor parameter
means, please refer to section 10 of the User Guide for Smart
Sensor Platform app and web portal for mechanical products
mentioned in section 14 of this guide.
5 DODGE® On-Premise Gateway User Guide