Adjusting The Anti-Scalp Rollers - Toro Z Master 77248 Operator's Manual

Adjusting the Height-of-Cut Pin
The height of cut is adjusted from 25 to 140 mm (1
to 5-1/2 inches) in 6 mm (1/4 inch) increments by
relocating the clevis pin into different hole locations.
1. Move the transport lock to the L
(Figure 33).
2. Push on the deck-lift pedal with your foot, and
raise the mower deck to the T
(also the 140 mm (5-1/2 inches) cutting height
position) as shown in
3. To adjust, remove the pin from the height-of-cut
bracket (Figure 34).
4. Select a hole in the height-of-cut bracket
corresponding to the height of cut desired, and
insert the pin (Figure
5. Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
Figure 34
1. Deck-lift pedal
2. Height-of-cut bracket
position
OCK
position
RANSPORT
Figure 34.
34).
3. Height-of-cut pin
4. Transport-lock lever
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
35.
g336602
1. Flange nut
2. Bolt
3. Bushing
31
Figure 35
4. Anti-scalp roller
5. Spacer
Figure
g036848