Toro Z Master 77248 Operator's Manual page 69

A. Raise the deck to the transport position
(12.7 cm or 5 inches).
B. Slowly loosen the adjusting screw on the
lift-assist spring until you can remove the
screw (see Figure
Note:
Save the screw for installation.
Rear discharge mower deck shown
1. Adjusting screw
2. Bracket
10. Place 2 blocks (see Block Height and Rake
Table) under the rear edge of the cutting deck
skirt; 1 on each side of the cutting deck
97).
11. Set the height-of-cut lever to the 3 inch (76 mm)
position.
12. Place 2 blocks under each side of the front edge
of the deck, but not under the anti-scalp roller
brackets or welds.
96).
Figure 96
3. Set the gap to 22 to 29
mm (7/8 to 1-1/8 inch).
1. Block—7.3 cm (2.87
inches)
Block Height and Rake Table
Deck
Size
All mower
decks
13. Carefully rotate the blades side to side
94).
g035850
14. Loosen the locknuts
and ensure that the mower deck is sitting
securely on all 4 blocks.
15. Remove any slack from the deck hangers and
make sure the deck-lift foot lever is pushed back
against the stop.
16. Tighten the 4 locknuts.
(Figure
1. Locknuts
2. Deck lift arm
69
Figure 97
Bottom view
2. Welds
Front Block Height Rake
7.3 cm (2.87 inches) 4.8 to 6.4 mm (3/16 to 1/4
inch)
(Figure
Figure 98
3. Deck hanger
4. Chain
g038090
(Figure
98) on all 4 corners
g035851