Dc Fans (Rear) - Sony F35 Maintenance Manual

. When installing the plug-in board, note the following:
When install the AT-173A and RE-241 boards
Route the harness (ETHER) as shown in the figure.
Cable guide sheet (lower)
Board rail (RE-241 board)
When install the VDA-67 board
. Pass the two coaxial cables through the rectangular
hole of the cable guide sheet (lower).
. Pass the two coaxial cables between the cable guide
sheets (upper), and route it as shown in the figure.
. Clamp the connecting point of the coaxial cables with
the inside coating lead pin.
Coaxial cable
Cable guide sheet (lower)
F35
Harness
(ETHER)
A T
A
V D
Harness
A D
(PS-RE)
VDA-67 board
Cable guide sheet
(upper)
Coating lead pin

2-3-3. DC Fans (Rear)

1. Remove the outside panel. (Refer to Section 1-4.)
2. Disconnect the harness (FAN-R) from the connector
(CN1) on the RE-252 board.
3. Disconnect the harness (RM) from the connector
(CN1) on the CN-2915 board.
RE-252 board
(CN1)
Harness
(FAN-R)
4. Loosen the two screws with stopper, and remove the
rear CN-BOX assembly.
5. Disconnect the four coaxial cables from the coaxial
connectors.
n
Be sure to hold the plug when disconnecting the
coaxial cable. Do not pull the cable.
Rear CN-BOX assembly
Screw
with stopper
blue
blue
F
G
Coaxial cables
Screw
Hold the plug to
OK
remove.
CN-2915 board
(CN1)
Harness
(RM)
Do not attempt to remove
NG
by pulling the cable.
2-7