Rear Section - Sony ZV-1 Service Manual

4-2-8. Rear Section

[ 11 ] RE-1006 flexible board
Refer to "Notes on Assembling
the RE-1006 Flexible Board (1)(2)(3)".
[ 1 ] screw
#239 (M1.4 X 1.4)
(0.12 ± 0.01 N·m)
(Note 1)
[ 3 ] MIC jack
plate (64500)
[ 2 ] screw
#115 (1.4 X 3.5)
(Tapping)
(0.12 ± 0.01 N·m)
[ 10 ] Shield sheet
RE-C (64500)
[ 7 ] BT insulating sheet (64210)
Refer to "Notes on Assembling
the BT Insulating Sheet (64210)".
[ 4 ] MIC holder (64210)
[ 6 ] LC lock (64500)
Refer to "Notes on Assembling
the LC Lock (64500)".
(Note 3)
[ 5 ] LC lock spring (64500)
Refer to "Notes on Assembling
the LC Lock Spring (64500)".
[ 17 ] Control switch bklock (SW63900)
Note 1
This screw cannot be reused. Discard the screw removed
once in servicing. Instead, use a new screw.
このねじは再利用することができません。
サービス対応時に一度でも外した場合は新品のねじと交換
してください。
[ 14 ] Main frame insulation (64500)
Refer to "Notes on Assembling
the Main Frame Insulation (64500)".
[ 8 ] Tape ASCD
Refer to "Notes on Assembling
the Tape ASCD".
[ 9 ] Disconnect the fine-wire
coaxial cable
(Note 2)
[ 19 ] MG sensor adhesive (64500)
[ 13 ]
Refer to "Notes on Assembling
the Main Frame Block".
[ 16 ] Main frame (64500)
[ 15 ] Frame sheet (64500)
[ 12 ] two screws
#174 (1.7 X 5.0) (Tapping)
(0.18 ± 0.02 N·m)
[ 18 ] Cabinet rear cover (64500)
(Note 4)
Sony CONFIDENTIAL
For Authorized Servicer
55
SYS SET