Sony F35 Maintenance Manual page 44

7. Disconnect the harness (REAR CA) from the connec-
tor (CN2) on the PS-724 board.
Coaxial cable
with connector
Yellow
Harness
(PS-REAR)
8. Remove the two hexagon socket bolts (3 x 8), and
remove the D-sub plate and the D-sub plate spring.
9. Remove the three screws to detach the CN-3000
board.
D-sub connector (with power)
Harness
clamp
B2.6 x 5
B2.6 x 5
CN-3000 board
Hexagon socket bolts (3 x 8)
10. Install the docking CN (R) assembly by reversing the
steps above.
n
For connecting the coaxial cable with connector, refer
to Section 2-10-1.
2-16
CN-3000 board
B2.6 x 5
(CN104)
Docking CN
(R) assembly
B2.6 x 5
CN-3000 board
(CN101)
Harness (REAR CA)
PS-724 board
(CN2)
D-sub plate
D-sub plate
spring
When it cannot be connected to external
equipment
It may be difficult to connect to the recorder or interface
box because of displacement of the D-sub connector.
In that case, adjust the D-sub connector positions by
loosening the two hexagon socket bolts (3 x 8) with the
wrench accommodated in the wrench box.
D-Sub connector
Hexagon socket bolt
(3 x 8)
Wrench box L-wrench
F35