Table of Contents
Advertisement
Jetter AG
Register numbers
Overview
Application-oriented manual – Control of alphanumeric HMIs (LCD) and printers
INFO
Further information
For a detailed description of the STX commands mentioned in
this chapter, see the JetSym Help at JetSym ST/STX projects
> JetSym STX programming language > Display commands
and user input .
4.1 Registers
INFO
Limitations
The settings made in the given registers take global effect,
meaning they will impact all functions for controlling printer
and serial interfaces. If different settings are used in several
tasks of the application program, then these settings may im-
pact each other.
The registers are clustered into one register block.
Basic register number
220000
In this chapter, only the last 4 digits of a register number are specified, e.g.
MR 2838. This is the module register. Add the basic register number of the corre-
sponding device to determine the complete register number, for example 222838.
4.2 Device numbers
The device number defines the output device. The device number is used as the
<DeviceNo> parameter with the DisplayText(), DisplayText2(), and Dis-
playValue() commands (see JetSym Help).
You may enter the following values for the parameter device number:
Number
Part
0
Default device
1
HMI 1
2
HMI 2
3
HMI 3
4
HMI 4
5 ... 7
Reserved
8
Printer module
Controlling printer and serial interfaces | 4
Register numbers
222806 ... 222838
Description
The device number to be used is con-
tained in MR 2824
Multi-display mode
Single-/Multi-display mode
Multi-display mode
Multi-display mode
Do not use
Output to a printer module on the JX2
system bus
45
Advertisement
Table of Contents
