Table of Contents
Advertisement
Jetter AG
MR 2840
STX command
Screen settings
Displaying numerical
values
Application-oriented manual – Control of alphanumeric HMIs (LCD) and printers
Control character for deleting a text string up to the end of a line
This module register contains the ASCII code of the control character deleting a
text string up to the end of a line.
Property
Values
Value after reset
Takes effect
Tab. 16: Control character for deleting a text string up to the end of a line
3.6 Displaying numerical values
To display numerical values, use the following STX command:
■
DisplayValue()
The format of numerical values can be adjusted to individual needs. To do so,
use the following parameters:
■
Display field length
■
Number of decimal places
■
With or without sign place
■
Displaying values in decimal or hexadecimal notation
When displaying numerical values, the following formatting applies:
■
The numerical value is displayed right-aligned.
■
The first character to appear in the display field is the sign unless writing the
sign character was disabled beforehand.
■
Positive numericals are prefixed by a space character as sign. Negative nu-
mericals are prefixed by minus '-'.
■
If the display field is too small, the leftmost digits are truncated.
■
The value is rounded to the set decimal places.
Description
0 ... 255
36 ('$')
Upon the next execution of the STX 'DisplayText()' or
'DisplayText2()' command
Control of alphanumeric HMIs | 3
25
Advertisement
Table of Contents
