41. Changing the thread monitor with free-arm cover
Note:
The thread monitor is only exchanged complete with the free-arm cover.
Removal:
•
Remove the machine's mains lead.
•
Remove the needle and presser foot.
•
Remove the folding cover.
•
Unscrew and remove both torx screws of the housing insert.
•
Remove the housing insert.
•
Raise both lugs 1 slightly and remove the facing panel of the front housing panel (fig. 102).
•
Place the machine on its back.
•
Unscrew and remove the three screws in the base plate.
•
Tilt the bast to the front and remove three connection plugs 4, 5 and 6 (fig. 103).
•
Unscrew and remove both fastening screws 7 of the free-arm cover (fig. 104).
•
Bring the feed-dog lowering mechanism into its normal working position.
•
Disengage both feed regulators 8 using a small screwdriver.
•
Remove the cable clip.
•
Remove connection plug 9 from the circuit board of the front housing panel and pull the cable
•
downward (fig. 105).
•
Remove the free-arm cover with the thread monitor from the housing to the left.
Fitting:
•
Install the new free-arm cover with thread monitor and secure with both fastening screws 7 (fig. 104).
•
Bring the feed-dog lowering mechanism into its normal working position.
•
Engage both feed regulators 8.
•
Place the cable, using a spring hook, between the motor and the housing.
•
Mount connection plug 9 onto the circuit board of the front housing panel (fig. 105).
•
Attach the cable clip.
•
Mount three connection plugs 4, 5 and 6 onto the circuit board of the base plate (fig. 103).
•
Fold the base plate to the machine and secure with the three fastening screws.
•
Mount the facing panel onto the front housing panel.
•
Insert the housing insert and secure with both torx screws.
•
Attach the folding cover.
•
Attach the mains lead.
•
Carry out a test of the thread monitor with an empty and a full bobbin.
96