Adjusting the machine:
•
Tilt the machine towards the rear.
•
Disconnect spring 3 (fig. 69).
•
Unscrew and remove screw 4.
•
Turn the handwheel until the lobe of feed eccentric 5 is at the rear.
•
Fold feed regulator 6 downward and remove it with link 7 to the left from feed bar pin.
•
Check that the slide block can be moved easily without play or binding into the slotted lever.
•
If necessary, adjust according to section 2.
•
Fold feed regulator 6 to the rear and then upward over feed eccentric 5.
•
Insert screw 4 into clamping plate 21 and tighten just a little.
•
Push pin 20 to the side until lever 7 and driving bar 19 still have a little play and move easily.
•
Tighten screw 4.
•
Attach spring 3.
•
Loosen the three screws 29 in the lower flat-toothed belt sprocket 102.
•
Bring the needle bar to its lowest position by turning the handwheel.
•
Fit spacer (63-102 600-18) on the needle bar and push up against the needle bar frame.
•
Push needle rise clamp (61-111 600-35) on the needle bar.
•
Push 2 mm feeler gauge (61-111 600-02) with its cutout on the needle bar above the needle rise
•
clamp.
•
Loosen the needle rise clamp and push the 2 mm feeler gauge upward against the spacer.
•
Tighten the milled screw on the needle rise clamp.
•
Turn the handwheel back and forth.
•
If there is any play at the feeler gauge, repeat this procedure.
•
Remove the 2 mm feeler gauge.
•
Turn the handwheel in the normal direction until the needle rise clamp rests on the spacer.
•
Hold the handwheel at this position.
•
Turn hook driving shaft 28 in the normal direction until the pin gauge can be inserted in the hole of
feed eccentric 5 and pins 27.
•
Insert the pin gauge and tighten one of the screws 29.
•
Remove the pin gauge, needle rise clamp and the spacer and tighten all three screws 29.
Note:
On having tightened the screws 29, there must not be any play between the lower flat-toothed belt
sprocket 102 and calotte 104.
•
Check section 4 „Adjustment of the feed dog height".
•
Carry out section 5 „Adjustment of the synchronizer".
•
Carry out section 14 „Sewing hook timing".
•
Insert the buttonhole sensor.
•
Attach the free-arm cover and fasten with both fastening screws 7.
•
Bring the feed-dog lowering mechanism to the normal working position.
•
Engage both feed regulators.
64