Foreword - Pfaff performance 2054 Service Manual

Foreword

This service and repair manual is intended to assist you in carrying out all repairs to the machines quickly
and correctly.
Adjustments should only be carried out if you find the actual settings deviating from the requirements
described here.
When checking or adjusting a machine, please always proceed in the sequence specified.
For easier reference every workstep is marked with a dot.
Differing worksteps are marked with a circle or square.
The indications „right", „left", „top", „bottom", „front" or „rear" always refer to the upright machine with its
controls facing the operator.
When assembling dismantled machines, make approximate adjustments right in the course of work.
This facilitates subsequent precise adjustments.
If not specified otherwise, the handwheel must always be turned to the front.
Always pull out the mains plug before making repairs to live parts or in their vicinity.
For correct adjustment of the machines, the following gauges and tools are required:
Needle rise gauge
Needle rise clamp
Spacer
Adjustment gauge for bobbin case position finger
Presser foot gauge
Pointer gauge
Pin gauge
Allen key 1.5 mm
Combination spanner (wrench) 6.0 mm
Torx screwdriver TX 6
Torx screwdriver TX 8
Torx screwdriver TX 10
Torx screwdriver TX 15
Torx offset screwdriver TX 15
Torx screwdriver TX 20
Torx screwdriver TX 25
Circlip fitting tool 2.3 kz
Circlip fitting tool 3.2 kz
Circlip fitting tool 4.0 kz
Circlip fitting tool 5.0 kz
Circlip fitting tool 6.0 kz
Circlip pliers A1
Spring hook
Subject to alterations in design and dimensions.
61-111600-02
61-111600-35
63-102600-18
61-111621-15
63-114690-39
63-114690-23
63-114690-09
07-433005-28
07-433007-50
07-434008-40
07-434008-41
07-434008-44
07-434008-45
07-434008-74
07-434008-46
07-434008-47
07-437003-20
07-437003-30
07-437003-40
07-437003-50
07-437003-60
07-438000-50
07-437006-00
5