Intelligent Flight Battery; Dji Intelligent Flight Battery Functions - dji MATRICE 300 RTK User Manual

MATRICE 300 RTK User Manual

Intelligent Flight Battery

Battery Introduction
The TB60 Intelligent Flight Battery has high-energy cells, and a smart charge/discharge functionality. It
should only be charged using appropriate DJI approved chargers. The Intelligent Flight Battery must be
fully charged before using it for the first time. The battery firmware is included in the aircraft firmware.
Make sure that all the batteries' firmware is up-to-date.

DJI Intelligent Flight Battery Functions

1. Battery Level Display: The LED indicators display the current battery level.
2. Charge or discharge the battery to 40% ~ 60% if NOT intended to be used for 10 days or more.
This can greatly extend the battery's overall life span. It takes approximately 6 days to discharge the
battery to 60%. It is normal that you may feel moderate heat emitting from the battery during the
discharge process. You can set the discharging thresholds in the DJI Pilot 2 app.
3. Balanced Charging: Automatically balances the voltage of each battery cell when charging.
4. Overcharge Protection: Charging automatically stops when the battery is fully charged.
5. Temperature Detection: The battery will not be charged to avoid damage when the battery
temperature is lower than -20 °C (-4°F) or higher than 45°C (113°F).
6. Over Current Protection: The battery stops charging when a high amperage is detected.
7. Over Discharge Protection: Over-discharging can seriously damage the battery. Current output will
be cut off when the battery cell is discharged to 3.2 V when not in flight mode. For extended flight
times, over-discharging protection is disabled as batteries discharge during flight. In this instance, a
battery voltage below 1.8 V may cause a safety hazard such as a fire when charged. To prevent this,
the battery will not be able to charge if the voltage of a single battery cell is below 1.8 V. Avoid using
any batteries matching this description and avoid serious over-discharging to prevent permanent
battery damage.
8. Short Circuit Protection: Automatically cuts the power supply when a short circuit is detected.
9. Battery Cell Damage Protection: DJI Pilot 2 displays a warning message when a damaged battery
cell is detected.
10. Sleep Mode: Sleep mode is entered to save power when the aircraft is not flying.
11. Communication: Information pertaining to the battery's voltage, capacity, current, etc. is transmitted
to the aircraft's main controller.
12. Heating: Batteries are able to work even in cold weather, ensuring a safe flight.
13. Waterproof and Dustproof: The aircraft has an IP45 Protection Rating , with the batteries installed.
Refer to the Disclaimer and Intelligent Flight Battery Safety Guidelines before use. Users take full
responsibility for all operations and usage.
34
©
2020 DJI All Rights Reserved.