Outbound Filtering - D-Link DSL-2730B User Manual

Section 3 – Configuration
To access Outbound Filtering, point to the Filtering Options on the left window and click Outbound Filtering submenu, or click the Outbound
button in the Filtering Options window.
The Outbound Filter allows you to create a filter rule to block outgoing IP
traffic by specifying a filter name and at least one condition on this
window. All of the specified conditions in this filter rule must be satisfied for
the rule to take effect. Filters are used to allow or deny LAN or WAN users
from accessing the Internet or your internal network.
Click the Add button to see the Outgoing IP Filtering section, enter the
information in the section. Explanations of parameters are described
below. Click the Apply button to add the entry in the Active Outbound IP
Filtering table. To remove an entry in the table, select the entry, and click
the Delete button. To modify an entry in the table, select the entry, click
the Edit button, make the desired changes, and then click the Apply
button.
Filters Parameter
Filter Name
Protocol
Select/Destination IP
Type
Source/Destination Port
Type
Source/Destination Port
D-Link DSL-2730B User Manual
Description
Enter a name for the new filter.
Select the transport protocol (TCP and UDP, TCP, UDP, ICMP or Any) that will be used for the filter rule.
Select the source/destination IP type. Available choices are: Any, Single IP, Network IP and IP Range.
Source/Destination IP Address&
Source Subnet Mask
Start and End Source/Destination IP
Address
The Source/Destination Port is the TCP/UDP port on either the LAN or WAN depending on if you are configuring an Inbound
Filter rule. The available selections are Any, Single Port and Port Range.
Enter a port or range of ports for the rule.

Outbound Filtering

This is the IP address and their associated subnets for which you are creating the
filter rule.
Enter the start and end IP address for the range of IP addresses which you are
creating the filter rule.
64