EverFocus KS-VM164 Operating Instructions Manual page 62

4.6 Telemetry protocol Pelco 'D'
As well as the usual Videotec and Macro protocols for telemetry control, the Aux line is able to control a line of
receivers with the Pelco 'D' compatible protocol.
4.6.1 Configuring the dome
Set up the dome for using the Pelco 'D' protocol (if more than one protocol is expected to be used) and set the
desired baud rate and identity number.
4.6.2 Configuring the switcher/matrix
4.6.2.1 Configuring t he Aux line
In menu 2.7 Configuration / Coax Transmission – Aux Line select the TELEM.PELCOD protocol and the
baudrate corresponding to that of the dome.
4.6.2.2 Communicati on with the keyboard
The protocol for communication with the keyboard should be MACRO and it is set by operating the dipswitch
inside the switcher/matrix. Set the baudrate as high as possible in relation to the distance and the conditions of
the connection.
4.6.3 Configuring the keyboard
4.6.3.1 Video Protoc ol
Set the video protocol (Communications / Video menu) as Macro and set the baudrate corresponding to that of
the switcher/matrix.
4.6.3.2 Telemetry Pro tocol
Set the telemetry protocol of line A (B) in the Communications /Telemetry line A (B) menu as Pelco'D' and the
connector as Video.
Make sure that in the Telemetry lines menu the Pelco type receivers are assigned to the appropriate telemetry
line.
Pag. 22 MNECKSVM164_0350