Extreme Networks 8720 Hardware Installation Manual page 41

Installing Your Device
c. Ensure that the slider assembly is level. If necessary, move it up or down at the
rear of the rack.
d. Snap the rear clamp into place. See Figure
Rear Rack Post .
Figure 11: Attaching the Slider Assembly to the Rear Rack Post
7. Repeat step 6 to attach the other slider assembly to the front and rear rack posts on
the other side.
Attaching the Switch to a Four-Post Rack
Attaching the Slider Assembly to the
Extreme 8720 Switch Hardware Installation Guide 41