de Troubleshooting
disturbance
Program duration change
changes during the
Washing process.
Water is not visible
in the drum
bar.
Drum jerks
Program start.
Vibrations and movement
the appliance during
spinning.
Drum turns,
Water does not run in.
Strong foaming
manure.
i-DOS
i-DOS
cannot be actuated
will.
High spin speed
number is not
reached.
66
Cause and troubleshooting
The foam control system switches on a rinse cycle if the
foam builds up too much.
No mistake - no action required.
▶
Water is below the visible range.
No mistake - no action required.
▶
Do not fill an additional one during operation
▶
Water into the device.
The cause is an internal motor test.
No mistake - no action required.
▶
Device is not aligned correctly.
Align the device
▶
The feet of the device are not fixed.
Fix the device feet. Align the device
▶
Transport locks are not removed.
Remove the transport locks
▶
Load detection is active.
No mistake, no action necessary.
▶
Note: The load detection can take up to 2 minutes.
Detergent dosage is too high.
Immediate action: Mix one tablespoon
▶
Softener with 0.5 liters of water and pour the
mixture into the compartment for manual dosing
(not for outdoor, sportswear and down textiles).
When intelligent dosing is activated,
▶
like the basic dosage → Page 45.
If you dose manually, decrease the
▶
the amount of detergent for the next wash cycle
with the same load.
Intelligent dosing is not planned for this program.
No mistake - no action required.
▶
Program progress does not allow intelligent dosing.
No fix possible.
The low spin speed is set.
Set a higher one for the next wash cycle
▶
Spin speed.