Activate Wi-Fi On The Device; Deactivating Wi-Fi On The Device; Software Update; The Device - Bosch WAV28K43 Instructions For Use And Assembly

Table of Contents

Advertisement

a If the display shows the
Time on z. B. 8 h changes, the
Smart Energy system (energy
manager) has specified a time at
which the device starts.
a When the smart energy system
(Energy manager) the device does
not start within the set time, the
device starts the program
independently before the set time
has elapsed. The program ends
when the time period expires.
Note
For security reasons, the Flex Start is
under the following
Conditions disabled:
¡ on Start / reload
¡ Open the door.
¡ Switch off the device.
¡ Power failure.
16.5 Activate Wi-Fi on the
device
Note: The energy consumption
increases compared to the values
given in the consumption value table
when Wi-Fi is activated.
on Remote start
1.
to press.
Set the program to position 4.
2.
a The display shows Con.
on Start / reload
3.
until the display On shows.
a Wi-Fi is enabled.
Note: The device does not turn off
automatically when Wi-Fi is activated.
16.6 Deactivate Wi-Fi on the
device
on Remote start
1.
customers push.
to press.
approx. 3 seconds
to press,
at least 3 seconds
Set the program to position 4.
2.
a The display shows Con.
on Start / reload
3.
until the display OFF shows.
a Wi-Fi is disabled.
Note: If Wi-Fi has been deactivated and
your device was previously connected
to your home network, the connection
will be automatically re-established
when you switch Wi-Fi back on.

16.7 Software update

Pre-condition: The display shows
UPd.
on Remote start
1.
to press.
Set the program to position 6
2.
len.
a Appears in the display UPd.
on Start / reload
3.
a The software update will be installed
lates.
a When the display End shows is
the software update is installed.
Note: The software update can take
several minutes. Do not switch off
the device during the software
update.
16.8 Reset network settings of

the device

on Remote start
1.
customers push.
Set the program to position 5
2.
len.
a The display shows rES.
on Start / reload
3.
a The display shows YES.
on Start / reload
4th
a The network settings are
set back.
Home Connect
to press,
approx. 3 seconds
to press.
at least 3 seconds
to press.
to press.
de
49

Advertisement

Table of Contents
loading

Table of Contents