de Troubleshooting
disturbance
"E: 35 / -10"
lights up.
flashes.
62
Cause and troubleshooting
Device is leaking.
Turn off the faucet.
▶
Call customer service.
▶
→
"Customer Service", page 74
The detergent drawer is not pushed in all the way.
Slide the detergent drawer up to
▶
Stop a.
Pump unit is not inserted.
Place the pump unit in the detergent drawer.
1.
→ "Cleaning the detergent drawer", page 52
Push in the detergent drawer as far as it will go.
2.
Detergent dosage is too high.
Immediate action: Mix one tablespoon
▶
Softener with 0.5 liters of water and pour the
mixture into the compartment for manual dosing
(not for outdoor, sportswear and down textiles).
When intelligent dosing is activated,
▶
like the basic dosage → Page 45.
If you dose manually, decrease the
▶
the amount of detergent for the next wash cycle
with the same load.
Temperature is too high.
Wait until the temperature has dropped.
▶
→ " Abort program ", page 43
▶
The water level is too high.
Start the program Pumping out.
▶
Laundry is jammed in the door.
Open the door again.
1.
Remove jammed laundry.
2.
Close the door.
3.
To start the program, press Begin/
4th
Reload
Door is not closed.
Close the door.
1.
To start the program, press Begin/
2.
Reload
.
.