Mounting; Installation Procedure - KROHNE Display and adjustment module for OPTISOUND sensors Operating Instructions Manual

Table of Contents

4 Mounting

Mount/Dismount display

and adjustment module

Mounting

4.1

The display and adjustment module can be inserted or removed at

any time. It is not necessary to interrupt the voltage supply.

Proceed as follows for mounting the display and adjustment module:

1. Unscrew the housing cover

2. Place the display and adjustment module in the desired position

on the electronics (you can choose any one of four different posi-

tions - each displaced by 90°)

Fig. 1: Insert display and adjustment module

3. Press the display/adjustment module lightly onto the electronics

and turn it to the right until it snaps in

4. Screw housing cover with inspection window tightly back on

Note:

If you intend to retrofit the instrument with a display and adjustment

module for continuous measured value indication, a higher cover with

an inspection glass is required.

Dismounting is carried out in reverse order.

Display and adjustment module for OPTISOUND sensors •

Table of Contents

Do you have a question about the Display and adjustment module for OPTISOUND sensors and is the answer not in the manual?