en
2.5
Installation / Dismantling
2.6
Maintenance tasks
2.7
Operator responsibilities
8
•
Always attach the lifting gear to the designated attachment
points (lifting eyes).
•
Position the lifting equipment in a way that ensures stability
during use.
•
When using lifting equipment, a second person must be
present to coordinate the procedure if required (e.g. if the op-
erator's field of vision is blocked).
•
Persons must not stand underneath suspended loads. Do not
move loads over workplaces where people are present.
•
Wear protective equipment:
Safety shoes
–
Safety gloves for protection against cuts
–
Safety helmet (when using lifting equipment)
–
•
Locally applicable laws and regulations on work safety and ac-
cident prevention must be complied with.
•
Disconnect the device from the mains and secure it against be-
ing switched on again without authorisation.
•
All rotating parts must be at a standstill.
•
Close the gate valve in the inlet and in the pressure pipe.
•
Provide adequate aeration in enclosed spaces.
•
Make sure that there is no risk of explosion when carrying out
any type of welding work or work with electrical devices.
•
Wear protective equipment:
Sealed safety glasses
–
Safety shoes
–
Safety gloves for protection against cuts
–
•
Locally applicable laws and regulations on work safety and ac-
cident prevention must be complied with.
•
The procedure described in the installation and operating in-
structions for shutting down the product/unit must be strictly
observed.
•
Only original parts from the manufacturer may be used for
maintenance and repairs. The use of any non-original parts re-
leases the manufacturer from any liability.
•
Disconnect the device from the mains and secure it against be-
ing switched on again without authorisation.
•
All rotating parts must be at a standstill.
•
Close the gate valve in the inlet and in the pressure pipe.
•
Store tools at the designated locations.
•
After completing work, reattach all safety and monitoring
devices and check that they function properly.
•
Provide installation and operating instructions in a language
which the personnel can understand.
Installation and operating instructions • Drive for Wilo-Helix2.0-VE / Wilo-Medana CH3-LE • Ed.02/2023-03