Adding Another Device To An Existing Wi-Fi Alarm Network - Kidde P4010ACSCOAQ-WF-CA User Manual

noTe: The alarm will mount to the bracket in 4 positions (every 90 degrees).
noTe: Installing the alarm on the mounting bracket will automatically activate the battery backup if it
hasn't already been activated.
B. Open the Kidde App and follow instructions on the App to finish Wi-Fi enrollment.
noTe: If no further steps are taken within 15 minutes of initial power up, a voice prompt, "Not Connect-
ed" will be heard once, and the Wi-Fi function will turn off. The unit will then perform as a standard
hardwired alarm. See Section 11.3 for reactivating Wi-Fi features.
C. After the Wi-Fi enrollment is completed, the alarm will announce "Success, now connected."
D. Repeat steps A through C with each alarm to be enrolled with Wi-Fi.

11.2 Adding Another Device to an Existing Wi-Fi Alarm Network

For various reasons, you might want to add additional units to your existing Wi-Fi alarm network. Modifying your
existing Wi-Fi alarm network is easy and user-friendly.
A. Follow wiring instructions and install the mounting bracket to prepare for
alarm installation (Section 9).
B. Activate the backup battery, apply AC power, install alarm. noTe: wi-Fi
features do not function without AC power.
• Locate the red wheel on the back of the device. Turn the red wheel to the
"ON" position on the device using a standard screwdriver. (Figure 11.2-B)
• Once the battery is activated, the device will emit a power on sound and blink green
once every two minutes.
• Connect the AC Quick Connector Harness. When AC power is connected,
the alarm will announce "Ready to connect, follow quick start instructions."
• Install the alarm fully on the mounting bracket by rotating the alarm in a clockwise direction.
noTe: The alarm will mount to the bracket in 4 positions (every 90 degrees).
noTe: Installing the alarm on the mounting bracket will automatically activate the battery backup if it
hasn't already been activated.
C. Open the Kidde App and follow instructions on the App to finish Wi-Fi enrollment.
noTe: If no further steps are taken within 15 minutes of initial power up, a voice prompt, "Not Connected" will
be heard once, and the Wi-Fi function will turn off. The unit will then perform as a standard hardwired alarm. See
Section 11.3 for reactivating Wi-Fi features.
D. After the Wi-Fi enrollment is completed, the alarm will announce "Success, now connected."
E. Repeat steps A through D with each alarm to be enrolled with Wi-Fi.
Figure 11.2-B
21