Adding Another Device To An Existing Wireless Alarm Network - Kidde 21027311 User Manual

The alarm is now activated! After installation / activation, test your alarm as described in Operation and Testing section.
WArnIng: fAIlUre to ProPerly InStAll And ACtIVAte thIS AlArM WIll PreVent ProPer
oPerAtIon of thIS AlArM And WIll PreVent ItS reSPonSe to fIre hAzArdS.
9.2 Adding Another Wireless Device to an Existing
Wireless Alarm Network
For various reasons, you might want to add additional units to your existing wireless alarm network. Modifying your
existing wireless alarm network is easy and user-friendly.
A. reMoVe the neW deVICe froM ItS PACkAgIng.
b. PoWer UP neW deVICe
Locate the red wheel on the back of the device being added. Turn the red
wheel to the "ON" position using the white activation tool included in the
Quick Start Guide or a standard screwdriver.
•
Once powered, the light ring will glow red.
C. PICk one InStAlled deVICe
Press and hold the button on ONE INSTALLED device on your network until
you hear two beeps. Release button. You will hear "Searching for other
devices."
•
Light will pulse green and device will sound a continuous "Sonar" ping
until step E is completed.
USE ACTIVATION
TOOL OR SCREWDRIVER
Figure 9.2-B
"Searching for
other devices."
Device Being Added
Installed Device
Figure 9.2-C
17