Adding Another Device To An Existing Wireless Alarm Network - Kidde P4010ACSCO-W User Manual

e. pICk one deVICe
Press and hold the button on only ONE device until you hear 2 beeps.
Release button. "Sonar" ping will stop.
•
Device will announce that setup is complete and the number of
connected devices.
F. SetUp CoMplete!
If all devices flash green and "Sonar" ping has stopped, the devices are now connected. Congratulations!
IMportAnt:
If for some reason, you forget which unit is the Coordinator, follow these simple steps to re-confirm
the coordinator and the RFD units.
1. Press and hold the button on any unit for 4-5 seconds until 2 beeps are heard. Release button.
2. Observe the LED ring on each unit. The Coordinator will be fading green on/off every 2 seconds. The RFDs will
be fading green on/off every 4 seconds.
3. After confirming the Coordinator, press and hold the button on any unit for 4-5 seconds until 2 beeps are heard.
g. proCeed to WIrIng InStrUCtIonS In SeCtIon 10.
9.2 Adding Another Device to an Existing
Wireless Alarm Network
For various reasons, you might want to add additional units to your existing wireless alarm network. Modifying your
existing wireless alarm network is easy and user-friendly.
A. reMoVe tHe neW deVICe FroM ItS pACkAgIng.
b. poWer Up neW deVICe
Locate the red wheel on the back of the device being added. Turn the red
wheel to the "ON" position using the white activation tool included in the
Quick Start Guide or a standard screwdriver.
•
Once powered, the light ring will glow red.
Hold for
5 seconds
Figure 9.1-E
USE ACTIVATION
TOOL OR SCREWDRIVER
Figure 9.2-B
17