Advertisement
CLX3300
Cylindrical Lockset
Installation Instructions
Lever Removal & Installation
9
a
Standard Cylinder (Figure 12)
To Remove:
Rotate key 45° and hold. Depress lever catch with lever release tool.
To Install:
With driver points at 6 and 12 (See Figure 16), rotate key 45° in
either direction and slide lever on over the lever catch. Confirm the
lever will not pull off.
b
Interchangable or Removable Core (Figure 13)
To Remove:
Remove core and tailpiece, using key marked "control."
Insert slotted screwdriver or lever release tool into cylinder opening and make
contact with lever catch.
Pull lever catch horizontally towards the opposite side of the cylinder opening
and remove lever.
To Install:
Without the core installed, slide the lever on over the lever catch. Confirm the
lever will not pull off. Install core and tailpiece, using key marked "control."
c
Plain Lever (Figure 13) & Push/Turn Button (Figure 14)
To Remove:
Depress lever catch with lever release tool, remove
lever.
To Install:
Slide the lever on over the lever catch. Confirm the
lever will not pull off.
Timing CLX3352 & CLX3382
10
1. Remove outside and inside levers. (See Section 9)
2. Adjust internal cams visible from both the outside
and inside lock trim.
2a. Use a slotted screwdriver to rotate each cam
until the driver points are in a 6 and 12 o'clock
position. (See Figure 16)
3. Re-install outside and inside levers.
4. Test both cylinders with key before closing the
door.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com •www.corbinrusswin.com
Copyright © 2021, 2022, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Figure 14
Figure 16
4
Lever catch
Control Key
View into lock from end of trim
12 o'clock drive point
6 o'clock drive point
Figure 12
Figure 13
Figure 15
FM566-EN 6/22
Advertisement
