Ariens GRAVELY Zoom & ZT Bagger Operator's & Parts Manual page 10

Hide thumbs Also See for GRAVELY Zoom & ZT Bagger:
Table of Contents

Advertisement

INSTALL FRONT WEIGHT TRAY &
COUNTERWEIGHT
WARNING: ALWAYS install counterweight
before operating unit with bagger attached.
ALWAYS remove counterweight when bagger is
removed from unit.
1. Remove the front footrest. There are two 1/2-13 x
2.00 (19) and 5/16-18 x 1.00 (10) Round Head
Square Neck bolts that secure the footrest to the
chassis. The 1/2-13 x 2.00 bolts (19) and metal
spacers are held on the fotrest by two 1/2 push nuts
(21). Twist or cut off the push nuts to remove them.
Save the spacers and discard all other hardware.
See Figure 4.
2. Lay the footrest onto the back of the weight tray
(similar profile). It may be helpful to have the weight
tray laying upside down on the ground when mating
it to the footrest. Install two 1/2-13 x 2.00 bolts (19)
thru the front of the weight tray and footrest. Slide
the two spacers (from step 1) over the bolts and
secure with push nuts (21). Snug the push nuts as
tight as possible. See Figure 4.
10
19
4
10
11
21
Spacer
Figure 4
3. Place the footrest/weight tray assembly over the
chassis. The two 1/2-13 x 2.00 bolts (19) will drop
thru the two holes in the chassis. You may have to
tilt the assembly back slightly to align the bolts with
the holes. Secure with two 1/2-13 nyloc flange nuts
(20). See Figure 5.
19
11
1
Front Footrest
Spacer
21
4. Install two 5/16-18 x 1.00 bolts (10) through the two
holes on the footrest portion of the assembly.
Secure with two 5/16-18 nyloc flange nuts.Adhere
the grip adhesive (4) just above the two bolts (10)
on the footrest, for additional grip. See Figure 4.
4
11
5. Place the cast iron weight (5) into the weight tray.
Install two 3/8-16 x 3.00 hex bolts (12) and two 3/8
lock washers (18) through the front of the weight.
There are two weld nuts on the back of the weight
tray. Thread the bolts into the weld nuts and tighten
until the lock washers engage. Do not overtighten
the bolts or the tray will flex. The bolts are only
installed to prevent the weights from falling out of
the tray. See Figure 6.
10
20
Figure 5
5
18
12
Figure 6
18

Advertisement

Table of Contents
loading

This manual is also suitable for:

815037815038

Table of Contents