Viking E-4 Installation Instructions Manual page 23

Motor Cable - Master (Dual)
peed peed Overlap Overlap
3 3
ormal ormal
Min Min 6 6
Center Center UL UL
ReOpen ReOpen
Loop Loop Sens Sens
Sens Sens
Loop Connector Loop Connector
Siren Siren
+ +
STEP 4
Master/Slave Configuration:
a. Install a jumper onto the "MS" Pin
Header.
VIKING TECHNICAL SUPPORT 1.800.908.0884
ODS ODS
0 0 100 100 0 0 60 60
Radio Radio
Rec. Rec.
Power Power
Low Bat Low Bat
Close Close
Siren Siren
+ +
4
Radio Station Radio Station
Aux. Aux.
Magnetic Lock Magnetic Lock
Pwr Pwr
+ - + -
Aux. Aux.
Magnetic Lock Magnetic Lock
Pwr Pwr
+ - + -
ELECTRICAL INSTALLATION
Timer Timer
Off Off
Master Master
4A 4A
Limit Open Limit Open
Limit Close Limit Close
Slave Slave
Limit Open Limit Open
Speed Speed Overlap Overlap ODS ODS
3 3
Normal Normal
Limit Close Limit Close
Max Max Min Min 6 6 0 0 100 100
Stop Stop Open Open
Center Center UL UL Radio Radio
ReOpen ReOpen
Rec. Rec.
Loop Loop Sens Sens Sens Sens
Close Close Stop Stop
Radio Station Radio Station
Guard Station Guard Station Loop Connector Loop Connector
Master Master
Guard Station Guard Station
STEP 5
Slave Motor:
a. Connect motor wires to the "Slave"
Terminal Block, according to the
opening direction as described on Page
20.
b. Attach the grounding wire, non
insulated, to the Board Mounting Plate
using the screw provided.
AC AC
AC AC
+ +
Bat Bat
- -
+ +
DC IN DC IN
- -
15A 15A
Speed Speed
Normal Normal
Timer Timer
0 0 60 60 Off Off
Max Max Min Min
Master Master
Limit Open Limit Open
Limit Close Limit Close
Slave Slave
Power Power
Limit Open Limit Open
Open Open
Low Bat Low Bat
Limit Close Limit Close
Slave Slave
Center Center
Master Master Slave Slave
ReOpen ReOpen
Loop Loop
5b
5a
Loop Connector Loop Connector
Overlap Overlap ODS ODS
3 3
6 6 0 0 100 100
UL UL Radio Radio
Sens Sens Rec. Rec.
Sens Sens
2 1
4A 4A
0 0
Radio Radio