Application Of Input Power; Disconnection Of Input Power; Communication Ports - Ametek Reichert ClearChart2 User Manual

Installation, Features, & Functions

Application of Input Power

1. Using the provided power cord, insert the female end into the power input recep-
tacle located at the bottom of the instrument.
2. Plug the male end of the power cord into a wall outlet of the appropriate voltage.
Input voltage must not exceed the range specified on the ClearChart 2 data plate.
3. Set the ON / OFF switch to ON ( I ).

Disconnection of Input Power

At any time, the power switch can be set to OFF. The unit does not have a power
down sequence. To terminate operation of the ClearChart 2, press the ON / OFF
switch to the OFF position (O).
Note: If the ClearChart 2 is intended to be OFF for an extended period of time, the
ClearChart 2 can be disconnected from power by detaching the power cord
from the receptacle.
Note: To extend the life of the screen, it is recommended to shut the instrument off at
the end of the day and on the weekends.

Communication Ports

The ClearChart 2 has a 9 pin female serial port on the bottom of the instrument hous-
ing that can be used for either hard-wired or wireless connection to the Reichert Auto
Phoroptor RS Auto Refraction system.
®
ClearChart 2 also has two exposed USB ports on the left side of the housing (when
facing the instrument) to power a wireless serial adapter.
ClearChart 2 Digital Acuity System User's Guide 13760-101 Rev. H
(continued)
9