kingsley-bate LO31 Assembly Instructions

LEGS

HARDWARE

STEP-I

Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the

Wood.

NOTE: During assembly of the furniture please match joints with the corresponding

letters or numbers stamped on wood.

STEP-II

Carefully lay the SEAT upside down on your clean surface, insert and attach the legs as shown

in the assembly photographs using the M6 x 50mm bolts provided. You may need to wiggle

the legs as you finish tightening the bolts to make sure they are fully secured.

NOTE: DO NOT USE POWER TOOLS AS IT MAY DAMAGE THE ITEM.

ASSEMBLY INSTRUCTIONS FOR THE LO31

SEAT

CONNECTOR

SEAT CUSHION

Table of Contents

Need help?

Do you have a question about the LO31 and is the answer not in the manual?

Page 1 ASSEMBLY INSTRUCTIONS FOR THE LO31 LEGS SEAT SEAT CUSHION HARDWARE CONNECTOR STEP-I Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the Wood. NOTE: During assembly of the furniture please match joints with the corresponding letters or numbers stamped on wood.
Page 2 STEP-III Place the SEAT CUSHION onto SEAT as shown in the photographs above. STEP-IV If you are connecting multiple sectional items together the photographs below illustrate where to attach them. DO NOT ATTACH THEM WHILE ITEM IS UPSIDE DOWN AS YOU WILL NOT BE ABLE TO UPRIGHT THE ASSEMBLY.