Table of Contents
Advertisement
LIGHTING INSTRUCTIONS
Follow these instructions for safe and proper lighting and re-lighting of the appliance.
CAUTION
• The Regulator supplied with this appliance is equipped with a Gas Flow Limiting Device
that will greatly restrict the flow of gas if activated by a rapid release of gas. Reference
Trouble-Shooting Tips if flame ever appears weak.
• If the appliance does not light after 2 or 3 attempts, turn OFF gas supply. Refer to Trouble
Shooting Tips and DO NOT attempt to operate the appliance until the problem is resolved.
WARNING
• Do not light burner at Air Shutter.
• Even if the flame is extinguished, the tank and regulator will still allow some gas to release
until they are fully CLOSED. You must allow gas to evacuate/dissipate before re-lighting.
Lighting the appliance:
1. Before lighting, completely turn off (close) the LP Cylinder Valve and the
Brass Valve to prevent any gas flow. NOTE: If the Brass Valve is left in any
other position, the Gas Flow Limiting Device will activate.
2. Turn on (open) the fuel supply by S-L-O-W-L-Y rotating the LP Cylinder
Valve one full turn.
3. Position a fireplace match or long lighter directly over the burner, then turn
on (open) the Brass Valve. The burner should light in less than 5 seconds.
Long Fireplace
Match
3
Air Shutter
4. After lighting the burner, visually check the burner and adjust to the optimal burner
flame. A blue flame with little or no yellow flame indicates a proper air/gas mixture
and provides the best heat. To adjust:
A. Fully open the LP Cylinder Valve
B. Turn Brass Valve to desired flame height/intensity
C. Rotate Air Shutter until mostly blue flame is achieved and
the flames burn at all ports without lifting above the burner.
5. If ignition does not occur in 5 seconds, completely turn off (close) the LP Cylinder Valve and the Brass Valve wait
5 minutes, and repeat the lighting procedure.
6. If the appliance is accidentally extinguished, completely turn off (close) the LP Cylinder Valve and the Brass
Valve, wait 5 minutes to allow gas to evacuate/dissipate, and repeat Steps 1 thru 4.
3a. It is possible to light this appliance with a
standard paper book match. To light:
A. BEFORE turning on (open) the Brass Valve,
strike the paper book match and place it in
the cup of the burner with the flame of the
match over the serrated edge of the flame
spreader.
B. Remove hand a safe distance from the
burner.
C. Turn on (open) the Brass Valve. The burner
should light in less than 5 seconds.
3a
13
LP Cylinder
Valve
Brass
Valve
Paper Book
Match
(hand away
from burner)
Flame
Spreader
Blue
Orange
CORRECT
INCORRECT
Advertisement
Table of Contents
